XDK API  3.6.0
Documentation
XDK Energy Management

Outlines XDKs Energy Management approach


XDK uses a reactive energy management approach. In general, components are only activated, once they are needed. The XDK API makes sure, that when you call the initialize function of a software module, all relevant hardware components and modules are powered up. In turn this means, that as long as you do not initialize a component (e.g. a sensor), this component does not consume power.

However, some uC peripherals are always powered up, when XDK boots. The following components are considered vital to XDKs operation and hence are always initialized:

Additional peripherals (such as the SPI module) are only initialized, when they are required (e.g. when initializing Wlan or the SD Card). The default initialization of the XDK SDK can be replaced, as outlined in XDK Software Startup Guide.

Sleep Management

XDK SDK currently does not support putting the MCU of XDK to sleep. While there is a software module called OS_SleepMgt, this module is neither used on XDK SDK nor has it been tested on XDK. Therefore, using it is at your own risk and may potentially be very frustrating.

XDK Battery Status

To determine the battery voltage of XDK, the battery is connected to pin PD7 of the MCU. This pin can be configured with the ADC_Driver software module to allow sampling the battery voltage. XDK uses a typical lithium-ion battery.

The battery charger of XDK gives information about the current charging mode via the green LED of XDK. However, this pin is not connected to the MCU. Determining the current charging mode in the software running on XDK is therefore not possible. The green LED only shows the charging status and cannot be controlled by software.

Green LED Charging Mode
Continuous Charging/Charging suspended by thermal loop
Flashing Safety timers expired
Off Charging done/Recharging after termination/IC disabled or no valid input power/Battery absent

All rights reserved. The use is subject to the XDK SDK EULA by Bosch Connected Devices and Solutions GmbH.
This documentation file has been automatically generated on Thu Mar 14 2019 19:12:49 by doxygen 1.8.8